this post was submitted on 27 Jul 2023
14 points (100.0% liked)
flashlight
2928 readers
10 users here now
Portable illumination
Rules:
- Be excellent to each other
- Don't be the reason we need to make more rules
Related:
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Thanks both of you. It was intended as a pure hardware question since I can make the software changes myself in principle. So I wanted to know if there were adc inputs on usable places for this on existing boards, and it sounds like there are not. Oh well.
As for the FET in turbo mode, good point. I'm mostly interested in the lower levels though.
I guess tailcap current measurements with a DMM are good enough for my purposes. It would just be cool if it were built into the light.
Only as long as you use a clamp meter.
Hmm is that to avoid voltage sag at high current? I think I'm satisfied with just low current, say below 0.5 amp at 1.2v (SP10 Pro on Eneloop) if I can do that with a DMM. I think a DC clamp meter that goes that low is quite expensive. Maybe someday.
if you have an emisar light and can disassemble it, then you can try soldering an airwire from the sense resistor to the button LED pad (sacrificing it for that) or a free ADC pin, but that's more difficult. If that cause problems with the current regulation, add a 10k resistor or the likes.
with a linear driver Iout=Iin so it's simple, with a boost driver Iin=(Vout x Iout)/(Vin x efficiency), thankfully Vin is already bein measured, Vout and efficiency need to be guesstimated.
Thanks, I do have a d4v2 but that's a level of modding that I wouldn't want to do for this. I s hoping enough capability might already be in the hardware, to make accessing it into a matter of programming. Maybe I'll just go with lux measurements.