poofy_cat

I didn't design it, but I'd like to try:

https://www.thingiverse.com/thing:126567

It's a 3d fractal made using code.

genius

0.2 mm normal in prusaslicer. I scaled the model up 150%, which made some of the overhangs just a little too steep so there are a few small gaps near the top.

Transparent PETG, and it's about 10" tall.

A whole lot lol. Replaced and heavily modified the extruder, extruder motor, filament runout sensor, bowden tube, hot end cooling fan, and part cooling fan/blower. Also had to take apart the hot end / heat break and clean out leaked globs that had stuck everywhere. Also modified the electronics cooling/intake fan setup with a dc/dc converter and 12v fans to reduce noise.