Can You Inject Hot Glue Into 3D Printed Molds? | DIY Cable Repair & Protection - spoiler: yes, it's neat by WaltzingKea in c/3dprinting@lemmy.world
[-] WaltzingKea@lemmy.nz 4 points 2 months ago

Yeah I guess heat-shrink would do the job most of the time. But for when you have connectors that are too big to fit the right heat-shrink over or want to splice more than 2 wires together and want a waterproof seal over them this could be useful.

What does your current setup look like? by WaltzingKea in c/selfhosted@lemmy.world
[-] WaltzingKea@lemmy.nz 13 points 7 months ago

Bad. I have a Raspberry Pi 4 hanging from a HDMI cable going up to a projector, then have a 2TB SSD hanging from the Raspberry Pi. I host Nextcloud and Transmission on my RPi. Use Kodi for viewing media through my projector.

1
Help finding value of burnt resistor. (lemmy.nz)
submitted 1 year ago by WaltzingKea@lemmy.nz to c/askelectronics@discuss.tchncs.de
0 comments fedilink

Mates bread maker stopped working so I had a look inside and saw this burned resistor.

I'm guessing the heat changed the colors a bit so wondering if anyone has experience in reading cooked resistor values.

I removed it from the PCB and measured it at 403 Ohms.

Thanks for any help.

WaltzingKea

joined 1 year ago