Microcenter ABS is pretty nice. In general they do some good stuff.
Of course you run exhaust fans! I run Bambi’s with enclosures, I don’t have an exhaust fan setup yet.
I often wonder about fumes and cancer risks.
Microcenter ABS is pretty nice. In general they do some good stuff.
Of course you run exhaust fans! I run Bambi’s with enclosures, I don’t have an exhaust fan setup yet.
I often wonder about fumes and cancer risks.
Not a direct reference of the Henry vi character
Adding in references, they are characters from Jeanne D’arc. It’s a lovely tactical rpg akin to Final fantasy tactics.
These are the main villains I believe
Liking the fine line work on this quite a bit.
I like the Thanksgiving undertones.
I get various cartoon dog vibes from this.
Yes in my experience, ABS is an easier print.
For ASA, I think maybe Sainsmart. They also do bad tpu, so maybe source was the problem.
How do you handle fumes with ASA? they are much worse than ABS, imo.
Hey! I was thinking about doing this.
Any useful info, should o give it a go?
Essentially. I was growing oregano, basil, flowers, and thyme in others.
Printed right side up. Everything was achieved via support setting optimization, and heated support removal where necessary (nose and lip in particular).
PLA holds up alright, but it’s gets brittle. There are just better choices.
Interesting point about the ABS, it appears to be holding up very good, but I’ll monitor it overtime.
ABS is nice, PETG good, ASA hard to print, PLA holds up(but don’t recommend).
White ABS is a classic