this post was submitted on 21 Jul 2023
1 points (100.0% liked)

Soldering

471 readers
2 users here now

This community is for electronic hobbyists to discuss projects and is focused on soldering. Everyone is welcome from the noob to people who have been soldering as a hobby for decades to people who solder professionally. We'll talk about materials and techniques, equipment, and projects. Everyone is welcome. All questions are welcome. Post photos and ask for help.

RULES:

  1. All Lemmy.ca rules apply here.

  2. Everyone (see rule 98) is welcome.

  3. If you’ve seen a question 100 times answer it the 101st time or ignore it. Even better, write a complete, detailed answer and suggest that the mod(s) pin it to the community.

[Did you actually think there were 98 rules?]

  1. If you present something as fact and are asked to provide proof or a source provide proof or a source. Proof must be from a reliable source. If you fail to provide proof or a source your post or comment may be removed.

  2. Don’t be a dick. Yes, this is a catch-all rule.

  3. The mod(s) have the final say.

founded 1 year ago
MODERATORS
 

We often get asked what we think of beginners first soldering projects then offer suggestions how to improve their technique, and often, how to rescue their project.

In this video I've done my best to do a bad job of soldering header strips onto a QFP32 to DIP32 adapter board. There are some cold joints, some dry points, some blobs, a solder bridge, and some nice, corroded peaks.

How do you fix this so that it looks like you're experienced and know what you're doing?

Liquid flux to the rescue (and clean, good quality solder and a hot soldering iron and a good drag soldering technique.)

If you try this technique please come back here and tell us how it worked out.

Hakko FM-203 with FM-2027 handpiece and T15-D16 1.6mm chisel tip

MG Chemicals 4884-227G Sn63/Pb37 solder

Kester 186 liquid flux

no comments (yet)
sorted by: hot top controversial new old
there doesn't seem to be anything here