this post was submitted on 24 Jul 2023
36 points (100.0% liked)

Home Improvement

9030 readers
2 users here now

Home Improvement

founded 1 year ago
MODERATORS
 

There are 3-4 spots like this. Want to make sure to discuss with contractor if I should prior to making last payment.

top 11 comments
sorted by: hot top controversial new old
[–] nowwhatnapster@lemmy.world 13 points 1 year ago* (last edited 1 year ago)

It's not ideal, but could be worse. The old decking gave way. Whether the roofers saw that and covered it up or it gave through when the air nailer got it is another matter. Most roofers would probably keep going till the job was done and address isolated issues like this after.

If decking repairs or a warranty were in your contract then they should make it right. If you don't have a contract then it's at the discretion of the roofers if they want to do anything about it.

Over the life of the roof that spot may wear prematurely or give way if any weight hits it. It's under a vent so there is probably a metal flange over it. So it might hold up. Time will tell.

It's certainly fixable. To do it the right way you need to take it all the way down to the decking and patch in a new board. Certainly doable, but kind of a pita.

[–] constantokra@lemmy.one 7 points 1 year ago (1 children)

That's not right at all, but I can see that it's a tricky spot, and your roof deck is boards instead of plywood... I dunno. If that was the only spot, i'd make them go in the attic and stick some wood in that gap. They can bridge from the other two boards and it won't be great, but it won't be horrible.

If there are more spots like this, i'd have another legit roofer who specializes in repairs (but ideally not full roofs) come out to inspect. Especially if the spots aren't also obviously small, and difficult to actually add any real sopport. He'll give you an unbiased opinion and tell you exactly what needs to be done to make sure you end up with a good roof, and likely give you an estimate in case you want him to do the work.

I know a good bit about roofing, and unless the roof was obviously done impeccably except for that, i'd be rather concerned. Sometimes it's best to just leave something alone and not get into another several thousand dollars worth of repair, and I don't know what that area of your roof looked like when he got down to the decking. A good roofer will. It's time to get some outside advice. The municipality where you live also likely has roofing inspectors who have to close out any permits the roofer pulled. You can contact them and they'll be glad to take a.look for free, but you might not get someone with as much knowledge as if you hire someone.

[–] HellmageTheVile@lemmy.world 1 points 1 year ago* (last edited 1 year ago) (2 children)

Planks were used in older roofs (which you probably know) which makes me think the decking is pretty old and probably should've been replaced with plywood.

[–] stealthnerd@lemmy.world 5 points 1 year ago* (last edited 1 year ago)

There's really no need to replace the decking unless it's damaged, regardless of it's age. It would be an unnecessary expense, and a large one a that.

That vent pipe is PVC which tells me it's a lot newer than this house so my guess would be that whenever that vent was added or replaced they destroyed that board in the process. Regardless, the roofers should have corrected it. It's possible they just forgot to circle back to it if this was the only issue.

[–] constantokra@lemmy.one 1 points 1 year ago

Plank decking is way better than plywood. You replace solid wood with solid wood, unless a ton of it has been compromised. This should be specified in the contract for the roof. You even get insurance discounts for solid wood. If a roofer replaced my boards with plywood or OSB i'd be super angry.

[–] Kathmandu@lemmy.dbzer0.com 3 points 1 year ago (1 children)

If someone steps on that, they are probably going to go through. The membrane looks solid, I don't know if with heat or age if a hole could form. When we reroofed my garage, we didn't leave any holes like that. Any soft spots got resheeted in plywood. Small gaps are probably okay, but that looks like 1 foot+

[–] RunningInRVA@lemmy.world 1 points 1 year ago

I agree. The manufacturer of the membrane would not have designed their product to operate over a gap like that. This to me would be the cause of accelerated wear and tear.

[–] RunningInRVA@lemmy.world 3 points 1 year ago

You can see the shingle nails coming through the membrane and are secured to nothing. A good wind could pull those shingles right off the roof.

[–] AtHeartEngineer@lemmy.world 2 points 1 year ago

If that's osb (plywood) on the other side of the wood, and it's small spots like that, I wouldn't worry about it.

[–] HellmageTheVile@lemmy.world 1 points 1 year ago (1 children)

That roof sheathing looks a little rough...

[–] mrecom@kbin.social 1 points 1 year ago

Do you mean around the pipe or the edge or just in general? They used all new materials for the sheathing and shingles.

load more comments
view more: next ›