this post was submitted on 12 May 2024
20 points (95.5% liked)

homeassistant

12072 readers
17 users here now

Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io

founded 1 year ago
MODERATORS
GreatAlbatross@feddit.uk
20
Local Only Water Meter? (lemmy.ml)
submitted 6 months ago by brownmustardminion@lemmy.ml to c/homeassistant@lemmy.world
9 comments fedilink hide all child comments
 

I tried my hand at rigging a proximity sensor to the water meter in my house. Sadly it doesn’t have the spinning magnet for the sensor to pick up.

I looked into other options for pulling data from the meter, but for each method, my very antiquated meter had a complication that would prevent it from working.

TLDR: Any recommendations for a home water meter that’s local and integrates well with home assistant?

I’m going to check with my water company first, but likely will remove the old meter and replumb a new “smart” meter and an automated shut off valve into the water supply. I believe the current meter is leftover from before the utility added new meters further upstream, so I’d rather get rid of the rusty piece of junk anyway.

you are viewing a single comment's thread
view the rest of the comments
[–] solidgrue@lemmy.world 14 points 6 months ago

Definitely check in with the utility before mucking with the meter. You can find your way into a lot of trouble tampering with active meters. Chances are there's new meter tech out your utility would install, and of which you could take advantage.

Check this thread. https://community.home-assistant.io/t/smart-water-meter/451935 . You'd install it down flow of your utility meter, and would need ESP32 to read the meter. It's a bit of work, but if you're already running ESPHome, it looks pretty straightforward.

On a long shot, you might consider looking into an inexpensively RTL-SDR software radio dongle, and use rtl_433 to scan a few common frequencies the utilities use to scan their meters from the street. I happened to find my neighbor's electrical meter on a common wireless weather station frequency, and if In were so inclined, could publish it to MQTT for HA to pick up.

Just a couple of ideas. Good luck!