3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
My only complaint about PrusaSlicer is that I regularly change settings in all three tabs for a change in filaments. What is "normal" for a balance in quality and speed differs between PLA and ASA, so I have to make profiles for "Normal ASA" and "Normal PLA". If I change nozzle sizes, it saves as a new printer, so I have "CR-10 0.4mm", "CR-10 0.6mm", etc. The optimal extrusion width changes with nozzle size, but extrusion width is a setting on the print setting, not the printer setting.
The point being, typically I have to change settings under all three tabs (print, filament, printer) for a change in filament. I know there's a retraction override tab on the filament, but I don't want two areas with retraction settings stored.
Minor note: it's a little annoying to swap to a new nozzle, create a new printer setting, and lose all filament settings. It's kind of a pain to find the PLA normal setting for 0.6mm nozzle and figure out how to copy it as a basis for the "CR-10 0.8mm" printer setting.