this post was submitted on 10 Jan 2024
17 points (94.7% liked)

Buildapc

3790 readers
26 users here now

founded 1 year ago
MODERATORS
17
submitted 10 months ago* (last edited 10 months ago) by MD756@lemmy.world to c/buildapc@lemmy.world
 

My MSI MAG Z790 motherboard supports rear channel speakers.

If I were to mount a pair of speakers behind me, that would require approximately 15 feet (4.5 meters) of speaker wire from my PC to the speakers. Do I have to worry about the AUX port’s power output if I were to use 18 or 16 gauge speaker wire?

you are viewing a single comment's thread
view the rest of the comments
[–] Octomagnus@lemmy.world 3 points 10 months ago (1 children)

Probably not. What is the impedance of the speakers?

[–] MD756@lemmy.world 2 points 10 months ago (1 children)

They're just some cheap speakers I found on Amazon: Theater Solutions TS30B

According to the product description: "frequency response is 140Hz-20 kHz with 89dB at 8ohm"

[–] glimse@lemmy.world 5 points 10 months ago* (last edited 10 months ago) (2 children)

Those are passive speakers that won't work without an amplifier. You need some PC speakers with an aux input

You can't go from 1/8" to speaker wire

[–] Telorand@reddthat.com 3 points 10 months ago (1 children)

8Ω is pretty low impedance. By comparison, the Sony MDR7506 is 63Ω, and they work just fine with the amp built into my mobo at only 10%.

Are you sure?

[–] glimse@lemmy.world 5 points 10 months ago* (last edited 10 months ago) (1 children)

I'm pretty confident but not 100% sure, I'm on my phone and only skimmed the manual.

Impedance isn't the issue here, headphones are completely different - their tiny speakers need significantly less power to drive them. I don't think the motherboard is capable of moving the cones in the speakers OP linked

The giveaway here is the inputs - your headphones have an aux (or 1/4"?) input and these speakers have speaker wire inputs

[–] Telorand@reddthat.com 3 points 10 months ago (1 children)

I mean, you can always solder a 1/8" stereo connector onto those wires, but the point about wattage isn't something to be ignored, and I forgot that.

Thanks!

[–] glimse@lemmy.world 3 points 10 months ago

I did some wacky cable conversions when I worked in the field but it was usually just to extend line level

Analog audio is fun lol

[–] MD756@lemmy.world 3 points 10 months ago (1 children)

Can’t believe I forgot to include that tidbit, that they’re passive speakers.

Isn’t the motherboard itself the amplifier?

[–] glimse@lemmy.world 5 points 10 months ago (1 children)

Unfortunately not, the motherboard only has a preamp. Those ports output a line level signal and the speakers are expecting speaker level which is post-amplification which is a MUCH stronger so it will be extremely quiet - if not completely silent

You can buy a cheap 2ch amp but I think you'd be better off with different speakers. It wouldn't be a bad idea to get a second set of whatever you're using for the front speakers to match the sound profile

[–] MD756@lemmy.world 2 points 10 months ago (1 children)

Thanks for the advice. I got a cheap amp, got it all set up, and it works a charm!

[–] glimse@lemmy.world 2 points 10 months ago

Nice!! Enjoy your surround sound