3DPrinting

15607 readers

269 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 1 year ago

MODERATORS

j4k3@lemmy.world

andypiper@lemmy.world

henry_rowengartner@lemmy.world

GrayBackgroundMusic@lemm.ee

Don't forget to change your z offset after swapping nozzles (programming.dev)

submitted 1 year ago by swordsmanluke@programming.dev to c/3dprinting@lemmy.world

21 comments fedilink hide all child comments

you are viewing a single comment's thread
view the rest of the comments

[–] swordsmanluke@programming.dev 3 points 1 year ago (1 children)

Thanks for the detail!

Fortunately, in this case I was using a brand new, low-quality nozzle I don't really care about.

After this, I did indeed notice that I hadn't tightened the nozzle fully tight and I had some mild "drizzle" escaping down the side.

Since then, I've

removed the nozzle
cleaned the gunk out
put the nozzle back in
leveled the bed
rechecked my z-offset

and... It's printing fine again.

Even the nozzle was alright... entirely due to dumb luck. 🤦

[–] thantik@lemmy.world 0 points 1 year ago

Yeah, the nozzles can survive a little bit of scrape-off like that, but it can change the orifice geometry so just be aware. What model/make of machine/hot end do you have, if you don't mind my asking? The cheap Ender-style PTFE-lined hot ends are pretty intolerant to just nozzle swaps, and if you have one of those, I have some videos I recommend watching so you know how to rebuild it properly should you ever need to again.