this post was submitted on 30 Sep 2023
442 points (96.6% liked)

Memes

45666 readers
1543 users here now

Rules:

  1. Be civil and nice.
  2. Try not to excessively repost, as a rule of thumb, wait at least 2 months to do it if you have to.

founded 5 years ago
MODERATORS
gary_host_laptop@lemmy.ml
sexy_peach@feddit.de
cyclohexane@lemmy.ml
cypherpunks@lemmy.ml
442
what the fuck does that mean (feddit.de)
submitted 1 year ago by nx2@feddit.de to c/memes@lemmy.ml
33 comments fedilink hide all child comments
 
you are viewing a single comment's thread
view the rest of the comments
[–] Bazinga@lemm.ee 13 points 1 year ago

That's because I asked it to explain the technical aspect of the question, not answer it.

Here's the answer it gave me when I asked it to answer the question:

Yes, I can provide an answer to the technical question in the photo.

The question is: "Can I attach a 10GBase-LR to QSFP-40G-LR4 (CWDM)?"

Answer: In general, you can't directly connect a 10GBase-LR transceiver to a QSFP-40G-LR4 transceiver because they operate at different data rates (10 Gbps vs. 40 Gbps). Additionally, the QSFP-40G-LR4 typically uses four separate lanes of 10 Gbps each, which is why it has the "4" in its name.

However, there are solutions to bridge these differences:

  1. Breakout Cables: You can use a 40G QSFP+ to 4x 10G SFP+ breakout cable. This cable will split the 40G signal from the QSFP-40G-LR4 into four separate 10G channels. You can then connect one of the 10G channels to your 10GBase-LR module. This will only utilize 10 Gbps of the 40 Gbps available from the QSFP+ port, leaving the other three channels unused.

  2. Transponder or Media Converter: These devices can convert signals between different data rates. A transponder could take in the 10G signal from the 10GBase-LR and output it as one lane of a 40G signal compatible with the QSFP-40G-LR4. However, similar to the breakout cable, this will only utilize a fraction of the 40G capability.

  3. Switch/Router Configuration: Some high-end networking equipment allows you to configure the data rate of specific ports. If both transceivers are plugged into such a device, you could potentially configure the QSFP-40G-LR4 port to operate at 10G, but this would be vendor and model specific.

Regarding the CWDM component, if both transceivers support CWDM and are operating on compatible wavelengths, they should be able to communicate over a CWDM system. However, CWDM is typically used to combine multiple signals onto a single fiber, so if you're just trying to connect these two transceivers, the CWDM component may not be necessary unless it's part of a larger network design.

Always consult with the documentation of your networking equipment and, if possible, conduct tests in a lab environment before making any changes to a live network.