Basically title, the top mount broke so I screwed the mount to a bench. Only seems to be happening with this filament though as I've been running this setup for at least 6 months.
this post was submitted on 30 Jun 2023
13 points (93.3% liked)
3DPrinting
15591 readers
70 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I think this can be caused by a filament that requires dehumidification .
Yup, looks like filament that took on moisture. Stick it in a bag with some silic get packs or a food dehydrator
I third this. Though, I recommend being careful with the food dehydrator, sometimes, they don't go low enough heat wise. Sometimes, the thermostats say one temp and it goes above at the top of the stack. generally, it should be tried at a little less than half the printing temperature (technically, below the glass transition temperature.).
also, it should be kept in there for some time to allow the moisture to equalize out. I usually put desiccant packs in the top to recharge them and store them with the filament.
oven with the door slightly open works too
*on warm, don't melt the filament lol
yeah don't accidentally a filament donut
You won't believe this 3D printing hack: How to print a 2kg donut in 20 minutes with solid infill!!!
Yup, looks like filament that took on moisture