3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
I change nozzles depending on the project.
0.4 and 0.5 are nice for smaller parts with fine details. But for mineatures / small figures, I tend to 0.3 or even 0.2 nozzles. 0.1 only for exceptional small and detailled works, since these nozzles constantly tend to clogging. And then there are taller parts which have to be strong, like shelf brackets or vases. That's where my 0.8 and even 1.0 mm nozzles do shine.
Last, but not least: You don't need a high-flow hotend for wider nozzles. Any hotend will do (tested with an old Ender2), as long as you adjust speed and temperature accordingly. Some trial and error is the key.
Side note: You don't need to level the bed after each nozzle change. Keeping this in mind saves quite some time and effort.