I read through the Meshtastic firmware code and found the file variant.h for the Meshtastic-DIY-v1_1 build. Notice it’s not the DIY-v1. Instead v1_1. My understanding from that file is that I should be able to wire the following:
ESP32 WROOM-32 dev Pin,Core1262-868M Pin,Function
3V3,VCC,Power (3.3V)
GND,GND,Ground
18,SCK,SPI Clock
19,MISO,SPI Data In
23,MOSI,SPI Data Out
5,CS,SPI Chip Select
33,DIO1,LoRa IRQ
32,DIO2,LoRa BUSY
27,RESET,LoRa Reset
14,RXEN,RF switch RX control
13,TXEN,RF switch TX control
Unfortunately after building out the DIY_v1_1 firmware, wiring it up and flashing it I get thrown into a boot loop only after setting the region.
I will provide logs once I’m able to do so, just wanted to submit this while I had time. I’m curious if I was misunderstanding the compatibility with a Core1262-868M or if anyone has any tips. Thanks.
Update : I have it working
UPDATE:
I was able to create my own variant under DYI. I took a look at the ai-c3 ( Core1262-868M ) and DIY v1_1 (esp32doit-devkit-v1) variant and combined them into a working configuration.
I'm going to call this new variant of the firmware, "aspec". Simply because when I first found out about this project, I assumed the SX1262 Core1262-868M and wroom-32 would just work out of the box with one of the million firmware variants available. "Amazon Special" ( aspec )
I also have a GPS that I'd like to add, so I'm going to keep playing around before I submit anything to the metastatic firmware repo.