this post was submitted on 31 Aug 2024
9 points (90.9% liked)
Ask UK
1226 readers
5 users here now
Community for asking and answering any question related to the life, the people or anything related to the UK.
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
If you trust your wiring skills you could theoretically just alter it to have a low-amp constant power source then higher-amp power source by adding the signals when the sensor trips... I think the issue is a lot to do with the fact LEDs are way less dimmable than older lights though, as dimmer switches cut off parts to the waveform so have lower rms voltage and flicker, whereas you'd want to supply the same voltage, just fewer amps... if you're keeping it constant I think it's very possible?
https://electronics.stackexchange.com/questions/218976/ac-constant-current-source-design - this in parallel with the motion activated circuit?